Custom pre-spaced vinyl lettering, logos, stickers and decals can be cut and delivered to end-users for easy DIY installation. Adhesive vinyl can be applied to virtually any smooth non-porous surface.

You need:

1. Towel - Paper towel is not preferred because paper dust may result unexpected bubbles
2. Scraper - For removing previously applied vinyl and remaining adhesive dirt
3. Adhesive Removing Fluid - Ready-made chemical for removing remaining old adhesive dirt
4. Squirt Bottle - Filled with ready-made application fluid or DIY mixture of 80% water and 20% dish soap.
5. Squeegee - To remove air bubbles when applying
6. Heat Gun or Hair Dryer - To speed up drying time

Steps:

1. Clean

   Scrape away all previously applied vinyl and remaining adhesive dirt Use damped towel to clean all dust on the surface

   
   
2. Peel

   Peel release paper backing

   
   
3. Spray

   Spray application fluid on the adhesive side of vinyl and surface with squirt bottle

   
   
4. Position

   Position the sign to the surface while the sign and the surface are wet

   
   
5. Smooth

   Smooth the sign into position If the sign does not slide, try to add more application solution

   
   
6. Squeegee

   Squeegee from center outwards to remove air bubbles